On an engine, we can divide it into several subsystems, and each subsystem has its own sensors. The intake system includes intake pressure sensor, air flow sensor; the oil circuit system includes rail pressure sensor and oil quantity sensor, as well as actuators (fuel metering unit); The timing system: crankshaft position sensor, camshaft position sensor; The circulation system: water temperature sensor.
Next, let's discuss these sensors: the intake system, the fuel system, the timing system, and the circulation system. When there is a signal input from these sensors, the ECU will receive this information. Each sensor will explain what it is for, what the normal voltage and data are, as well as common faults and symptoms. Now, let's study:
The commonly used sensors on common rail engines are:
Intake pressure and temperature sensor
Oil pressure and temperature sensor
Rail pressure sensor
Water temperature sensor
Throttle pedal sensor
Atmospheric pressure sensor
Crankshaft speed sensor
Camshaft position sensor
The types of sensors are classified as: active and passive. Any sensor that requires a 5V power supply from a computer during operation is called an active sensor; conversely, it is called a passive sensor.
The intake system is an essential component of an engine. The quality inspection of intake air is a necessary step for engines with higher emissions under the National Ⅲ,National Ⅳ, NationalⅤ,National Ⅵ Standards. Only by knowing the intake volume can the optimal air-fuel ratio be determined, and the exhaust emissions can be optimized. In the intake system, there are mainly sensors, including intake pressure sensors and intake oil quantity sensors. The intake pressure and intake oil quantity sensors are used to measure the intake volume, but they have different design structures and principles. For heavy-duty vehicles on the road, intake pressure and temperature sensors are used, while on passenger car engines, intake oil quantity sensors are used.
The intake pressure sensor is usually installed in front of the intake pipe and measures the pressure in the high-pressure gas path. It is also known as intake pipe pressure and boost pressure. However, in the diagnostic system, it is also referred to as intake pipe intake pressure and boost pressure. For a normal vehicle, the amount of intake air is within the normal range. We can view the data stream through the decoder, and there are reference standards for the data stream. Regarding the classification of common rail engines on the market (taking six-cylinder and four-cylinder engines as examples), at the highest speed of the empty vehicle, how mucht he intake volume should be? The rated speed of common six-cylinder engines is usually below 2500 rpm and above 3000 rpm. For example, the J6 truck with Xichai's 350 or 390 horsepower engine, the rated speed of this vehicle is usually below 2500 rpm. For this case, at the highest speed of the empty vehicle (while idling and refueling), the intake pressure needs to reach above 120 kPa (kpa), which is the minimum requirement.
However, for the same type of six-cylinder engine with lower horsepower, the typical rotational speed is around 3000 rpm. At the maximum rotational speed without load (while refueling at the same location), the intake pressure needs to reach 140 kPa or higher. For a four-cylinder engine, if the rated rotational speed is above 3000 rpm, the intake pressure needs to reach 130 kPa or higher. This is also the case at the maximum rotational speed without load. If the rated rotational speed of a four-cylinder engine is above 4000 rpm, the intake pressure needs to reach 160 kPa or higher at the maximum rotational speed without load. That is to say, when diagnosing the vehicle for faults, one should first consider having different intake pressure standards for engines with different rotational speeds and different cylinder counts. The above information is only for reference.