1. The starter does not turn.
First, check if the system power supply (24V) is normal and if the fault indicator light is on (the system is normal when not in operation). Secondly, inspect the gearshift switch, key switch and starter to ensure they are functioning properly.
2. The starter is functioning properly, but black smoke is emitted during startup, and the engine fails to start.
The emission of black smoke indicates that the fuel supply system is normal. The main issue to be addressed is whether the phase of the Ne and G sensors is correct. Additionally, the two wires of the Ne sensor must not be connected in reverse.
3,The starter is functioning normally, but there is white smoke during startup, and the engine fails to start.
This indicates that there is partial fuel supply.
Use the diagnostic tool to monitor the actual rail pressure during startup (normally it should be 40 MPa, and when white smoke is emitted, it is generally less than 40 MPa). This shows that there is a leakage in the common rail system. Due to the low rail pressure, the starting fuel volume decreases, resulting in poor atomization and thus the emission of white smoke and inability to start.
4,The starter is functioning properly, there is no black smoke or white smoke, but the engine fails to start.
This phenomenon has many possible causes. Using a diagnostic tool, generally there is no actual fuel pressure or very low pressure.
1. The air in the fuel inlet pipe has not been completely discharged, especially for newly assembled vehicles, when the engine was manufactured, the coarse filter had no diesel in it;
2. The diesel fuel intake is not smooth, such as if the fuel inlet pipe is skewed, this condition cannot be detected by hand pump;
3. The common fuel pump PCV1 and PCV2 are simultaneously disconnected (mainly check the PCV relay);
4. The fuel injector is faulty, for example, if the front end of the fuel injector is loosened, the engine cannot start. If multiple fuel injectors leak, the engine cannot start either, but at this time, if the common rail pressure sensor is unplugged, the engine can start (mainly because this time the starting rail pressure is artificially increased);
5. The contact of the common fuel pump PCV1 and PCV2 is not good, the contacts have corrosion, resulting in insufficient fuel supply for a short period of time;
6. The common rail pressure sensor is faulty. For one vehicle, when it failed to start, the voltage of the common rail sensor measured was around 4.6V, but it had not reached the alarm value of 4.88V, so there was no flashing code. Because the ECU detected a high rail pressure, the fuel pump would not increase the fuel supply to the common rail, thus causing the engine not to start. This situation can be determined by unplugging the rail pressure sensor to start the engine;
7. The common rail pressure limiting valve is leaking (this can be detected using a diagnostic tool. When the limiting valve is open, the rail pressure is 30MPa);
8. The engine stop switch is faulty (the switch is closed);
9. Finally, the ECU power supply system must be checked.
① The voltage at pins 46 and 56 of the ECU after the key switch (normal around 24V);
② The voltage at pins 5, 6, and 7 of the main relay after the ECU (normal around 24V);
③ The voltage at pin 68 of the diagnostic switch (normal around 10V);
④ The voltage at the main contacts of the PCV relay (normal around 24V).