The lubrication system consists of an oil tank, oil pump, filter, cooling device, heating device, oil pipelines, safety devices, alarms, and other components. Its main function is to deliver a specified amount of lubricating oil to the surfaces of parts, reduce wear on mechanical components, and clean and cool the part surfaces.
I. System Structure
1. Oil Pan
1.1 Also known as the lower crankcase, it is located at the bottom of the engine. Its functions are to collect and store lubricating oil, dissipate some heat, and prevent the lubricating oil from oxidizing. It is removable and contains an oil stabilizing baffle inside.
1.2 A dipstick is installed on the side. The oil volume must be between the upper and lower marks on the dipstick, and an oil drain plug is installed at the lowest point of the bottom.
2. Oil Pump
2.1 Its function is to draw oil from the oil pan and forcibly deliver it to the moving surfaces of various engine components.
2.2 During cold starts, because the oil viscosity is high and resistance is relatively large, the system pressure may be temporarily higher than normal.
3. Oil Filter
3.1 Also known as the oil filter element, it is used to remove impurities such as dust, metal particles, carbon deposits, and sludge from the oil as it circulates and from the surfaces of parts.
4. Oil Cooler
4.1 The oil cooler is placed in the cooling water circuit, using the temperature of the cooling water to control the temperature of the lubricating oil.
4.2 The function of the oil cooler is to keep the oil temperature within the optimal operating range. If the temperature is too high, the load-bearing capacity of the oil film decreases; if the temperature is too low, the oil's fluidity deteriorates.
5. Pressure Relief Valve
5.1 It is generally installed in the oil passage at the outlet of the oil pump or on the oil filter base. It is a safety valve in the engine lubrication system, mainly used to limit the upper limit of oil pressure and prevent damage to oil passage seals or the oil pump caused by excessive pressure.
5.2 When the oil pressure exceeds the set value, the pressure relief valve opens automatically and returns excess oil to the oil pan, thereby stabilizing the system pressure. It can also provide bypass oil supply when the oil filter is clogged, preventing wear of critical components due to oil starvation.
6. Oil Pressure Sensor
6.1 The oil pressure sensor is installed on the engine's main oil passage. It converts the pressure signal into an electrical signal, which is then amplified in voltage and current and connected to the oil pressure gauge through a signal wire.
6.2 When the pressure falls below the alarm voltage, the alarm circuit outputs an alarm signal and lights the warning lamp through the alarm wire.
7. Oil Pressure Gauge: Monitors the pressure in the main oil passage in real time and provides operating indications for the operator.
II. Working Principle
1. Basic Principle: The oil pump draws oil from the oil pan. After filtration and cooling, the oil is delivered under a certain pressure to the friction surfaces of the crankshaft, connecting rod, camshaft, and other components to form an oil film. The lubricated oil then flows back to the oil pan, repeating the cycle.
2. Typical Oil Path: Oil pan → oil strainer → oil pump → oil cooler → oil filter → main oil passage → various friction surfaces → return to the oil pan.
3. Return Cycle: Under the action of gravity, the oil flows back along the wall of the engine block to the oil pan. The oil returning to the oil pan carries frictional heat and heat conducted from combustion, and awaits being drawn in again by the oil pump. After passing through the cooler and filter, it re-enters the circulation.