+86-15123173615

Analysis of Denso Common Rail Injector Performance

Nov 03, 2026

The selection of fuel injection systems for diesel engines significantly impacts engine power and efficiency. Different fuel control systems greatly influence engine performance parameters. The injector is a key factor affecting engine fuel economy, as it has a major impact on fuel atomization quality, injection duration, and the interaction between the fuel spray pattern and the combustion chamber. Therefore, the selection and research of injectors in fuel injection systems hold substantial practical value. Compared with traditional S-series and P-series injectors, common rail injectors offer superior performance, including higher injection pressure, better atomization, improved fuel efficiency, and reduced noise pollution. Market penetration of these injectors has been steadily increasing year by year, driven by the growing adoption of Euro III common rail systems. This article provides a brief analysis and introduction to the performance of common rail injectors, using Denso's products as an example.

 

I. Overview of Denso Common Rail Injectors

1. The common rail injector receives signals from the engine's electronic control unit (ECU) to deliver pressurized fuel from the common rail into the engine combustion chamber. It ensures precise injection timing, appropriate fuel quantity, and optimal injection mode and rate tailored to the engine requirements.

2. The injection is controlled by a two-way valve (TWV) and an orifice. The TWV serves two functions: first, it effectively controls the pressure in the control chamber; second, it regulates the start and end timing of the injection. The orifice controls the injection rate by restricting the speed at which the nozzle opens.

3. The pressure from the control chamber is transmitted to the nozzle needle, controlling the piston to open and close the valve.

4. When the injector needle valve opens, the fuel nozzle sprays the atomized fuel, achieving the purpose of fuel injection.

 

II. Working Principle of Denso Common Rail Injector

 

info-717-318

 

The Denso common rail injector achieves fuel injection by controlling the fuel pressure within the control chamber. The two-way valve (TWV) regulates the fuel pressure in the control chamber primarily by controlling fuel leakage within the chamber. There are various types of TWVs, which vary depending on the injector design.

1. No Injection

When the TWV is not energized, it blocks the overflow passage of the control chamber. As a result, the fuel pressure inside the control chamber equals the fuel pressure applied to the nozzle needle-both being equal to the rail pressure. At this point, the injector needle valve remains closed because the pressure difference between the pressure-bearing surface of the control piston and the spring force of the nozzle prevents fuel injection.

2. Injection

When the solenoid valve (TWV) is energized, it pulls up, opening the overflow passage in the control chamber and allowing fuel to flow out from the chamber, thereby reducing pressure. As the pressure in the control chamber drops, the force on the injector needle valve overcomes the downward spring force, pushing the needle valve upward and initiating injection. The fuel flow rate is restricted by the orifice, so the injector opens gradually during operation, resulting in a continuously increasing injection rate. When current continues to be applied to the solenoid valve (TWV), the injector needle valve reaches maximum lift, achieving peak fuel injection rate and maximum fuel delivery.

3. Injection Termination

When power to the solenoid valve (TWV) is cut off, the valve drops down, closing the overflow passage in the control chamber. Fuel pressure within the control chamber immediately returns to rail pressure, causing the nozzle to close and stopping injection.

 

III. Drive Circuit for Denso Common Rail Injector

To improve the sensitivity of the common rail injector, the drive voltage is increased to a higher level, accelerating the magnetization of the electromagnetic coil and enhancing the response speed of the solenoid valve (TWV). The EDU or charging circuit within the ECU boosts the battery voltage to approximately 100 V, which is then applied to the injector via the injection signal generated by the ECU, thereby improving the injector's responsiveness.

Send Inquiry