The main malfunction of fuel injectors is blockage, which will affect the normal injection and atomization of gasoline, causing a decrease in engine power, slow acceleration, unstable idle, and easy stalling.
1) Listen to the working sound of the fuel injector: After the engine heats up, let it idle and place a screwdriver or stethoscope above the fuel injector. If you can hear a crisp, uniform, and rhythmic "click, click" sound from each cylinder's fuel injector, it indicates that the fuel injector is working properly. If the working sound of a cylinder injector is very low or cannot be heard, it indicates that the cylinder injector is not working properly or has completely failed, and the injector and control circuit should be inspected. If the engine noise is loud and not very obvious, you can unplug the fuel injection harness plug and test whether the noise disappears. If the working sound of each cylinder injector is clear and uniform, it indicates that the injector is in good condition.
2) Cylinder by cylinder fuel cut-off inspection: After the engine heats up, let it idle and sequentially unplug the wiring harness plugs of each cylinder's fuel injector to stop fuel injection. If the engine speed significantly decreases and the exhaust pipe makes a "popping" sound after unplugging the fuel injector harness plug of a certain cylinder, it indicates that the fuel injector is working normally.
3) Unplug the wire connectors of each fuel injector and check the resistance of the injector. If the resistance value does not match the specified value, the fuel injector should be replaced.
4) The malfunction of the external circuit of the fuel injector can be checked using the test lamp method. Connect a 12V test light between the two terminals of the fuel injector connector, then start the engine and observe the flashing changes of the test light. If the test light flashes, it indicates that the fuel injector control circuit is normal. Otherwise, it indicates that there is a fault in the circuit or control computer.
5) The performance of the fuel injector unit can be tested by supplying power to the fuel injector separately. Connect the 12V power supply to one terminal of the fuel injector connector, ground the other end, and then disconnect it. Repeat this process and listen for the sound of the fuel injector. If the fuel injector can make a short "click" sound every time it is grounded, it indicates that the fuel injector has good performance, otherwise it is a fault and needs to be replaced.