The main components of the engine crankshaft and connecting rod are the bearing (sliding bearing, thin-walled bearing made of babbitt alloy (copper-lead alloy); roller bearings are only seen in older models, two-stroke engines, and some racing/specialty engines. The following is a comparison of them separately.
1. Principle
1. The bearing (sliding bearing, thin-walled bearing made of babbitt alloy/copper-lead alloy) bears the load through the oil film between the shaft journal and the bearing; there is no direct hard contact between the shaft and the bearing (ideal liquid friction), it is a surface contact.

2. Roller bearing (rolling bearing, including cylindrical rollers, needle rollers) transmits the load through the rolling of the rollers, it is a line contact; the rolling elements roll between the inner and outer rings, the friction is rolling friction.

2. Core advantages and disadvantages
1. Bearing (sliding bearing)
Advantages:
1. Large bearing capacity, strong resistance to impact and overload, suitable for the alternating impact load of the crankshaft;
2. Compact structure, small radial size, convenient for reducing the engine volume;
3. Smooth operation, low vibration, low noise;
4. Mature processing, controllable cost, suitable for large-scale vehicle engines;
5. The oil film has certain "buffering and vibration absorption" capabilities, better accommodating the slight deformation and eccentricity of the crankshaft;
6. After wear, there is a wear-in process, the lifespan is long under normal lubrication.

Disadvantages:
1. Must have a continuous and stable oil supply; once the oil supply is cut off for a few seconds, the bearing will burn out and the shaft will seize, the oil pressure and oil quality requirements are high;
2. During startup and low-speed stage, the oil film has not been established, it is boundary friction, the wear is the greatest during startup;
3. The friction loss is slightly higher than that of the rolling bearing (the normal high-speed oil film friction is actually not much, but the low-speed difference is significant);
4. The wear gap is not easy to detect directly, burning out is a serious single failure, the repair cost is high;
5. High requirements for the surface roughness, roundness, and coaxiality of the crankshaft.

Roller Bearings (Roller/Needle Bearings)
Advantages:
1. Low friction resistance during startup, making cold start easier;
2. Low requirement for lubrication pressure, no need for high oil pressure, and better oil starvation tolerance than bearing shells;
3. Lower friction loss in low-speed range;
4. Gap is visible, wear can be determined by the clearance;
5. Partial disassembly and maintenance can replace the bearings separately.

Disadvantages:
1. Weak resistance to impact and alternating loads: The crankshaft experiences repeated impact, and the rollers are prone to pitting, peeling, and track indentations.
2. Larger radial space occupation, making it difficult to achieve a compact design for the engine.
3. High-speed rolling body centrifugal force is large, limiting the maximum speed, and high-speed noise and vibration are more likely to occur.
4. Extremely sensitive to coaxiality and installation accuracy; slight deformation of the crankshaft can easily cause jamming and early damage.
5. Higher cost, and large-scale mass production of gasoline engines and diesel engines rarely uses it.
6. Once it fails, it is mostly in a fragmented or stuck state, with sudden failure occurrence; there is no oil film buffering.

3. Applicable Scenarios for the Engine
Wear Sleeves (Main Type): The vast majority of automotive four-stroke gasoline/diesel engines, including crankshaft main bearings and connecting rod bearings.

Roller/needle bearing: Older single-cylinder diesel engines, two-stroke engines, motorcycle crankshafts, a few racing cars, and small special-purpose power units; nowadays, roller bearings are rarely used in the main crankshafts of automobiles.